Nod Engine SDK => Mapping in Embrace => Topic started by: Mort on 2011-05-07, 17:52:42

Title: Issues with water
Post by: Mort on 2011-05-07, 17:52:42
Long time no see.

Been playing around with embrace again and ran into an issue.  Im making a water area that I want to be walk- throughable....  I have used the tutorial on this page to do so but for some reason even though I have made the water brush set to "detail," I still can't walk through it even though the floor under it is walkable.  I have even tried removing the water brush completely to check to see if there is a pathing issue or something, though the walkable area is accessable and walkable.

After reading my export log i found this:


I am assuming this is my issue?  Is there a way I can fix this?
Title: Re: Issues with water
Post by: Javokis on 2011-05-13, 22:55:03
Try NOCSG instead of DETAIL. See if that works.