Please Help Support by Donating

  • 2021-01-18, 03:38:16
  • Welcome, Guest
Please login or register.

Login with username, password and session length
Advanced search


Looking for VTMR Modding Tutorials? Check out the Modding Tutorials section of

Author Topic: Walking through a table  (Read 2902 times)


  • Member
  • *
  • Karma: 2
  • Offline Offline
  • Posts: 52
Walking through a table
« on: 2013-06-05, 10:43:01 »

I've created a table by using brushes. A regular rectangle as the top and four other brushes as legs. The problem is that I can walk right through it. They are not set to walkable. Should I use any other brush setting or is something else wrong? The tabletop is 1 cell high at grid size 8.


  • Horses Dick
  • Member
  • *****
  • Karma: 22
  • Offline Offline
  • Posts: 2389
Re: Walking through a table
« Reply #1 on: 2013-06-05, 10:47:43 »

Make sure it's fully connected to the floor... it might be floating a bit above a walkable floor. Try cutting the floor beneath it too and make that section "non-walkable."
"There's nothing wrong with horses dicks, there's nothing wrong with sucking horses dicks." -Signo

Page created in 0.04 seconds with 26 queries.